If after following the provisioning procedure the phone does not configure itself remaining in the factory configurations (the display shows “No Service” and the time is probably incorrect), check that the provisioning via DHCP option is OFF.
Read More
Yealink IP Phones support a recovery mode that uses the TFTP protocol. When a phone does not regularly access the network, no longer presents the configuration pages via the web or has accidentally turned off during an FW update, the following procedure may be useful. Firmware recovery procedure Set up a TFTP server with the […]
Read More
Answer an incoming call Using the receiver: Pick up the handset Using the hands-free mode Press the button Using headphones: With the headset connected, press to initiate communication
Read More
1. During a call, press the button under the “Transfer” label to put the active call to be transferred on hold; 2. Dial the number to which you want to transfer the call followed by pressing the button under the “Transfer” label.
Read More
1. During a call, press the button under the “Transfer” label to put the active call to be transferred on hold. 2. 2. Dial the number to which you want to transfer the call followed by pressing the key . 3. After speaking with the interlocutor, press the button under the “Transfer” label to complete […]
Read More
To create a three-way conference: 1. Call the first participant; 2. Press the button under the label “N. Ch. ” to create a new call and automatically put the active call on hold; 3. Call the second participant; 4. When the second participant answers, press the button under the “Conf” label to join all the […]
Read More
Basic functionality of the Yealink T19P phone Making a call Using the receiver Lift the handset; Dial the number; Press the button located under the “Send” label on the display Using headphones With the headphones connected, press Enter the number, then press “Send”
Read More
When on a call, pressing with the microphone off you can hear all the other participants in the call / conference call. To enable the microphone, press again
Read More
Redial Press the button under the label “Reg. ch. ” to view the list of calls made. Press and to scroll to the desired number, then press the key .
Read More
Incoming calls can be rejected by pressing the key located under the label “Reject” on the display during the call signal.
Read More
