RESTART THE PHONE Press button X for at least 10 seconds and wait for the restart confirmation message to appear: press OK to accept, X to reject. RESET TO FACTORY SETTINGS Press the OK button for at least 10 seconds and wait for the reset confirmation message to appear: press OK to accept, X to […]
Read More
In this article, we describe how to set daylight saving time on Polycom phones certified by VOIspeed. We remind you that these configurations are automatically applied through the self-provisioning of the terminals. First you need to access the phone’s web interface and navigate to the Preferences -> Date and Time section Then fill in the […]
Read More
In the default settings, new calls made from the Polycom IP phone with the handset on hook are diverted to the speakerphone. To set the headset connected to the phone as the default device, enter the web administration of the phone, Preferences menu – Other preferences – User Preferences – Automatic detection of headset mode […]
Read More
If you happen to need to update Polycom phones that can’t surf the net and you can’t set up an auto-provisioning server that requires you to activate option 66 in the DHCP server, you can have the firmware downloaded from a local server via the web just like you would do if phones surfed. Just […]
Read More
The configuration of the terminals certified by VOIspeed should always be carried out with the Autoprovisioning function Yealink T52P IP DECT Phone Configuration The Yealink W52P IP DECT phone with default settings automatically searches for a DHCP server on the network during boot to obtain a valid IP address. For the use of the terminal […]
Read More
If after following the provisioning procedure the phone does not configure itself remaining in the factory configurations (the display shows “No Service” and the time is probably incorrect), check that the provisioning via DHCP option is OFF.
Read More
Yealink IP Phones support a recovery mode that uses the TFTP protocol. When a phone does not regularly access the network, no longer presents the configuration pages via the web or has accidentally turned off during an FW update, the following procedure may be useful. Firmware recovery procedure Set up a TFTP server with the […]
Read More
Answer an incoming call Using the receiver: Pick up the handset Using the hands-free mode Press the button Using headphones: With the headset connected, press to initiate communication
Read More
1. During a call, press the button under the “Transfer” label to put the active call to be transferred on hold; 2. Dial the number to which you want to transfer the call followed by pressing the button under the “Transfer” label.
Read More
1. During a call, press the button under the “Transfer” label to put the active call to be transferred on hold. 2. 2. Dial the number to which you want to transfer the call followed by pressing the key . 3. After speaking with the interlocutor, press the button under the “Transfer” label to complete […]
Read More
